Recent content by sschevy

  1. Looking for shoot pits in NH, are there any in the Hampstead area?

    those days are not gone , again it happens in my neighborhood daily, they are shooting in the conservation land across from me literally every day
  2. Looking for shoot pits in NH, are there any in the Hampstead area?

    Depending on where in Hampstead you are the shooting you are hearing is literally right across the street from my house you’re welcome 😊
  3. Colt Vs SW

    You lost me at Sig Romeo 5 and the 1200 lumen light
  4. AR help - please :)

    awesome!!! 👍 I’m going to clean them out right now before they’re gone forever 😂
  5. AR help - please :)

    That's sort of what I was trying to check. If you mix up spring, buffer, stock tube length and gas system, you get funky dwell times, over gassing. Hangs. Locks, etc. Just measure everything and look and you will be fine. A miss gassed system will fire a few shots, but it will quickly get ahead...
  6. AR help - please :)

    Those were the best ones , but I believe they are discontinued By colt , haven’t seen them in stock for a long time now
  7. AR help - please :)

    I remember , Laura ... you don’t want to get into a gunfight against Laura 😂😂
  8. AR help - please :)

    I don’t know who it was , but in his defense decent parts are getting very hard to find these days and sometimes you don’t know you got sub par parts until it’s too late
  9. AR help - please :)

    Was I grumpy that day?? if so I apologize sometimes they beat me down as the day drags on 😂😂😂
  10. AR help - please :)

    one does work better , absolute fact if the problem persists Daniel Defense makes a .315 front pin upper which makes the cam pin unnecessary
  11. AR help - please :)

    I’m there 10-4 tomorrow
  12. AR help - please :)

    Peabody right on Rt 1 northeast arms
  13. AR help - please :)

    In a perfect world you want MPI and HP stamped on both the bolt and barrel
  14. AR help - please :)

    I doubt you goofed the upper or lower the cam pins have been getting difficult to source the past few years and you may just have a crappy pin a good quality can pin will cost around $30 , a lot of money for such a small item but a well machined pin will be pricy , you may want to try another...
  15. AR help - please :)

    no doubt , text can be the worst!! 😂
Top Bottom