80%

I saved one lower twice. The person was just jamming the drill in the pin holes and
it snapped off in the lower. I gave him one of mine to complete. Then later I was able
to mill the pocket down to the Broken bit and get it out.

The Same lower I was tapping the Rear Detent hole for a 4-40 Set screw and snapped the tap
in the Lower. I took the smallest End Mill I had (5/64") and milled around the tap until I could
get a pair of needle nose pliers on it and turn it out.

If you do this mod to put an 1/8" 4-40 set screw in, then cut 1/8" off the spring. This detent will
will not come out if you remove the stock.

Malodave
 
i'm a photographer not a machinist... i tried an 80% 10/22.... i might take that, call it a half-assed pistol and bring it to a buyback for some stop n shop gift cards...
I have my associate of Arts Degree in Photography. I took my Avatar Pic.

I do Machinists work with my own Baby Bridgeport Clone with 3 Axis DROs.

I am also building an Airplane.

P8190021.JPG
 
I use the real software, Photoshop. Been using it since Version 2.5 back in '93.
My mill is setup at my work in Hollis NH.
Malodave
ahh see, they both work together, LR is a management tool to keep things organized and do RAW conversion, then PS is is good for fixing/replacing, that sorta thing...
 
Back
Top Bottom