I built this guy a couple of weeks ago and all is well with it:
http://www.northeastshooters.com/vb...t-should-I-look-out-for?p=1779094#post1779094
All except for one thing. I have some pre-ban Thermold magazines (made in NC, not Termelts) and they seem to work ok in my XCR. In my AR, it seems the feed lips are too thick or something and when I release the bolt, it gets hung up about 1/2 way. It does not do this on any of the USGI mags I have or the few English Defense mags I have.
If I can't make it work, it's not a big deal. However, is there a way to adjust something to make this work?
http://www.northeastshooters.com/vb...t-should-I-look-out-for?p=1779094#post1779094
All except for one thing. I have some pre-ban Thermold magazines (made in NC, not Termelts) and they seem to work ok in my XCR. In my AR, it seems the feed lips are too thick or something and when I release the bolt, it gets hung up about 1/2 way. It does not do this on any of the USGI mags I have or the few English Defense mags I have.
If I can't make it work, it's not a big deal. However, is there a way to adjust something to make this work?
