Glock 19 Pre-Ban Followers

[MWL556]

Need to replace the followers in my G19 pre-ban high-caps... Does anyone know how to get a positive ID on the type of follower I need?

From what I know, there is a number after "9mm" on the follower that is the key. Pre-Bans and "earlier" models look like they're different than newly mfg'ed ones.

Just want to hear from someone who has experience with this, before I order... Side note - Do any shops in the Southern NH or eastern MA areas stock them?

Thanks!

 

[shanef]

Just the mag body needs to preban... You can change springs, followers, and base plates...

 

[Scarab440]

from my research for U notch you want 9mm3 and for square you want 9mm6

 

[Queen Bee]

from my research for U notch you want 9mm3 and for square you want 9mm6

+1

 

[MWL556]

Thanks! Just ordered a few online.

 

[Shprockets]

Thanks! Just ordered a few online.

Its an old post but hopefully still read, I'm trying to find some. where did you purchase yours from?

 

[dcmdon]

I have U notch G19 mags. I run the followers from the Gen4 mags. I'll check for the number in a few minutes.
Combined with a wolf mag spring, gunsprings.com, they run flawlessly on both Gen4 and Gen5 G19s.

They do not however lock the slide back on an empty mag.

I don't consider this to be a problem because I don't usually carry an extra mag anyway.