Glock 22 Gen 2 Trigger Assembly Question

[BillyBoy]

Guys,

Tonight I did the 3.5 trigger pull mod on my Glock. I was watching a Youtube video as a guide since this was my first time doing it. I noticed in the film I was watching there was a spring which was part of the assembly (trigger spring). I noticed on my Glock I didn't have a spring and instead I had a spring loaded lever:

So I was looking online and noticed in Glock 22 schematics that there should be a spring present (#25 in the schematic).
http://www.e-gunparts.com/productschem.asp?chrMasterModel=2440z22

My guess is that this lever part is present in the gen 2's but not in the newer gens? Was wondering if someone had an explanation to this?

 

[Buzzards Bay Tactical]

You have a New York Trigger Spring. I have to check but I don't think you should use a 3 1/2 lb connector with it.
o.k. I just checked NY Trigger Springs should only be used with a 4.5 or 5.5 connector.

 

[jenlynn724]

yep.. NY trigger, 3.5 should not be used with that.

 

[BillyBoy]

Ok thanks for the info guys!!!! Could I replace the trigger mechanism with this one and be OK?
http://glockparts.com/?mainURL=/store/category/62nn/Trigger_Mechanism_Housings.html

 

[Buzzards Bay Tactical]

You don't have to replace the Trigger Mechanism Housing. Just pull the NY Trigger out. There should be a small hole in the rear of the housing and on the trigger bar. This spring goes in between : http://www.midwayusa.com/viewproduct/?productnumber=157451

 

[BillyBoy]

I was just about to ask that cause it seems I can take that lever piece out. I do have the trigger spring handy so I'll give that a shot. Thanks for all the help guys. Good thing I asked about this!!!

 

[BillyBoy]

Just finished the mod appropriately thanks to Trav! Good thing I had the spring handy!!!