Thanks in advance; and yes I’ve been looking for an answer...but I can’t find anything even remotely helpful...
So I’m reaching out to NES:
I recently bought a Cobray PM-11 that came with the “ball” magazine latch system. In the back of the grip (on the receiver) the hole that the grip-mount-screw, (top pic, top screw) seems to be “oversized” and had some sort of mechanism on the inside of the mag well that held the screw in place (see pics - it’s the big silver shiny washer-looking thing - second pic, upper right)....(you can see how it juts into the mag well in the last pic)
I bought a traditional magazine release & grip - but due to the fact that the hole is too big for the screw, how should I address this?
Has anyone encountered this before?
I have already looked through the loose screw section at my local hardware store and they didn’t have anything that was “short” enough while being “wide” enough.
Thanks in advance
So I’m reaching out to NES:
I recently bought a Cobray PM-11 that came with the “ball” magazine latch system. In the back of the grip (on the receiver) the hole that the grip-mount-screw, (top pic, top screw) seems to be “oversized” and had some sort of mechanism on the inside of the mag well that held the screw in place (see pics - it’s the big silver shiny washer-looking thing - second pic, upper right)....(you can see how it juts into the mag well in the last pic)
I bought a traditional magazine release & grip - but due to the fact that the hole is too big for the screw, how should I address this?
Has anyone encountered this before?
I have already looked through the loose screw section at my local hardware store and they didn’t have anything that was “short” enough while being “wide” enough.
Thanks in advance
