looking for a guinea p.., eergh, a volunteer. :)

paul73

NES Member
Joined
Oct 30, 2020
Messages
15,528
Likes
18,462
Location
MA
Feedback: 6 / 0 / 0
so, as some may know - i make some stuff for reloading that i sell, among that stuff - a lubricating adapter. as i own a Dillon xl750 press - it is all made for 750/650.

So, the point is - i am looking for anyone who would like to try out and advise on fitment for the design of the same thing made to fit a dillon 1100 or 1050 presses - see image below.
For now, it is a pistol caliber optimized model, so, if you have a 1100/1050 and reload pistol brass - let me know, here or over PM, if you`d be interested.
ideally, it would be best to meet around framingham, if you can, to avoid wasting $ on shipping, but, shipping is also possible.

Thx.


1050.jpg
 
Last edited:
If you’re 3D printing parts for reloading presses, how about a primer catch for a Hornady LNL single stage!
this?

look for it in there - what part you need. i bet that stuff already exists, it is not new.
 
Back
Top Bottom