Reply to thread

I only have two Microtech knives at this point. One Hera and one Cypher II. I like both, just wish they didn't use the proprietary screws for the Hera. I sent off a message earlier today about either getting the screws on the Hera changed out to torx, or getting a driver bit so that I can tighten them as needed. Will see what they come back with. For those who will comment about getting the bit from any sources, NONE of those (that I've picked up) work. The amount of space around the screws is so little that it looks like a complete custom driver bit is needed. I've bought a few different bits hoping that one would work. Nope.


Back
Top Bottom