Also, the pistol is susceptible to limp wristing, specifically, the last two failures mentioned below FTF and FTE. Though some claim that they have experienced failure to return to battery.
It's not a 1911, so when firing, hold the damn pistol, just don't go overboard with a death grip, which will cause you to hit low and to the left.
How limp wristing can cause a failure to cycle
Depending on the operating mechanism, there are a number of places that limp wristing can cause a failure to cycle.
Recoil operated firearms are more susceptible to failure of this type than
blowback and
gas-operated firearms, and lightweight
polymer framed handguns are more susceptible than heavy
steel framed handguns. When there is not enough energy to move the slide back far enough relative to the frame to cycle the action, it is called limp wristing. When there is too much energy in moving the slide back relative to the frame, it is called slide slam.
In blowback and gas operated firearms, the slide reacts against the frame pushing the frame forward slightly against the recoil of the bullet leaving. In recoil operated firearms, the slide reacts against the bullet, and the frame is under no force at the time of firing. As the slide begins to recoil to the rear some of that energy is transmitted to the frame through the locking mechanism (in locked breech designs) and the recoil spring. This transmitted energy accelerates the frame to the rear as well. If the frame is not sufficiently restrained by its mass and the shooter's grip,
the frame will "catch up" to the slide, and the recoil spring will not be fully compressed,
and the slide will return forward under less than the designed force.
One common result of limp wristing is a
failure to eject, as the slide will be moving too slowly at the point where the ejector is activated. The slow moving case will be caught as the slide closes, resulting in a
stovepipe jam. These jams can be easily dealt with by knocking the used brass out of the way with the side of your hand or closed fist. The other common result of limp wristing is a
failure to return to battery;
the slide will be moving too slowly to move the new cartridge fully into the chamber, so the slide will stop partially open. The least common form of failure is a
failure to feed,
where the slide returns to battery on an empty chamber, because the slide moved back just far enough to eject the fired cartridge, but not enough to strip the next round from the magazine.