Having some trouble with my Pyramid drop in trigger.
I finally pushed the sights onto the green monster, loctited down the RMR cover plate and took it to the range. The first magazine produced excellent results at about 20' so I loaded up a second mag and about 4 shots in shit went weird. The gun basically went to burst mode, first it doubled, then tripled and I shot the f***ing target hanger clip off in surprise.
I did some more delicate testing with just a couple rounds in the magazine, trying to reproduce what happened and diagnose what the problem was. Turns out the trigger reset is so short that even the barest twitch of my finger on the trigger will cause a followup shot.
Turns out it seems to be a not uncommon issue with pyramid triggers. Rather than f*** around with it, I'm thinking about just pulling it completely and dropping in the stock trigger assembly that came with the frame parts kit.
Anyone have any thoughts on this before I start pounding out pins?
Also, should be noted that I have the 2lb firing pin spring and a 13lb recoil spring with stainless steel guide rod installed. Trigger spring is the one that came with the pyramid kit. There were absolutely no problems cycling, FTFs, or FTEs in the about 30-40ish rounds I put through it last night.