If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/Pioneer Valley Arms April Giveaway ***Smith & Wesson SD9VE 9MM***

Reply to thread

Message

Most likely the pin is not too deep into the barrel. Try this: put a lever into the end of the muzzle device and turn it a little clockwise and then a little counter clockwise, you will have to use a little mussel to get it to start to move, the weld will most likely start to break. Once it starts to move start rocking to clockwise and counterclockwise back and forth. There is a good chance that the pin will back out enough to unscrew the MD.

[QUOTE="JDL, post: 5378227, member: 52637"] Most likely the pin is not too deep into the barrel. Try this: put a lever into the end of the muzzle device and turn it a little clockwise and then a little counter clockwise, you will have to use a little mussel to get it to start to move, the weld will most likely start to break. Once it starts to move start rocking to clockwise and counterclockwise back and forth. There is a good chance that the pin will back out enough to unscrew the MD. [/QUOTE]

Verification