Reprofile S35VN

[Lsgun1]

Ok, so how long does it take everyone to reprofile to 30 inclusive with this steel? I'm using a sharpmaker with diamond rods.

knife is a ZT 450CF that was never very sharp out of the box.

 

[86 power]

I’ve never had luck re-profiling on the sharpmaker. I have to use my wicked edge for that

 

[DK12]

I know this is old.... Any reprofiling work shouldn't be done with a system like that. Unless you have the diamond stones to go with it. Even then, very long job. Look into a KME system. Sort of pricey, but they are great for people with very little experience