MassG-19
NES Member
This Stock is great condition, taken off of the Sig MCX purchased in August of last year before this latest infringement on our rights went into effect. I needed to get a little bit more height to get a good eye box behind my LPVO. I tried adding a this slightly higher cheek riser. I wound up taking the stock off the rifle and just buying an aftermarket stock with a non-folding mount.
The compliance work was done on the folding hinge before I picked it up which consisted of a a tiny weld across the hinge. Because you have to unfold the hinge in order to remove the stock from the mount I had the compliance work removed and restored it to its factory condition once it was off the rifle. It’s currently fully functioning as intended by Sig and not installed on a rifle.
There are a couple of close-up pictures of where the compliance work was removed, barely noticeable.
$225/OBO
The compliance work was done on the folding hinge before I picked it up which consisted of a a tiny weld across the hinge. Because you have to unfold the hinge in order to remove the stock from the mount I had the compliance work removed and restored it to its factory condition once it was off the rifle. It’s currently fully functioning as intended by Sig and not installed on a rifle.
There are a couple of close-up pictures of where the compliance work was removed, barely noticeable.
$225/OBO
