Spacer

[M1911a1g17]

Good evening all

Was hoping any might have a lead on where I can a spacer? These are the dimensions:
.205 in long
.532-.535 inside diameter
.570-.571 outside

It is for a pistol barrel and comp set up.

 

[MAJoe]

With those very specific measurements, you’re best off going to a local machine shop and having them cut one. You can get spacer stock from McMaster or similar, but nothing exactly to what you want.

 

[M1911a1g17]

@MAJoe thank you! I appreciate it. Do you have one you recommend?

 

[pastera]

What material?
Tolerance on the 0.205"

There are several online machine shops that can turn that out fast and cheap.

 

[MAJoe]

@MAJoe thank you! I appreciate it. Do you have one you recommend?

No problem! And no, unfortunately I don’t have any recs. The online route is something I haven’t thought out but sounds like a good option for something so small and simple.

 

[M1911a1g17]

I need it for a comp to barrel. The comp has an inner but thT tightens down onto the barrel and then the body sleeves on and tightens by a locknut.