If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/Pioneer Valley Arms April Giveaway ***Smith & Wesson SD9VE 9MM***

Reply to thread

Message

Not sure about Woolwax/NH Oil, but Fluid Film is like paste out of the can. You need to warm it up just to pour it. I don't think an airless would cut it even with a large nozzle.

I got this setup that is designed to spray fluid film. It works good but to get good volume I still have to crank my compressor up to around 100psi.

I like the (2) wands. One is a straight pattern and the other has holes on the sides (4 @ 90 degrees OC). So that works great for inside frame holes or door bottom drain holes.

[ATTACH=full]753571[/ATTACH]

[QUOTE="Coda, post: 8472462, member: 68147"] Not sure about Woolwax/NH Oil, but Fluid Film is like paste out of the can. You need to warm it up just to pour it. I don't think an airless would cut it even with a large nozzle. I got this setup that is designed to spray fluid film. It works good but to get good volume I still have to crank my compressor up to around 100psi. I like the (2) wands. One is a straight pattern and the other has holes on the sides (4 @ 90 degrees OC). So that works great for inside frame holes or door bottom drain holes. [ATTACH type="full"]753571[/ATTACH] [/QUOTE]

Verification