Redsoxnation151
NES Member
- Joined
- Jun 16, 2021
- Messages
- 92
- Likes
- 36
Selling a used Dillon XL650 with extras shown below:
Dillon Electric Case feeder with 9mm feeder plate
Inline Fabrication Raised Mount
Dillon OEM toolhead
Dillon Carbide 9mm dies
Dillon 9mm conversion kit
Lee Factory Crimp Die
Powder measure assembly
Powder Measure Sensor check alarm
Roller handle
Original ball handle
All new springs (all springs for whole press)
Extra 9mm Dies: Lee 9mm B6 Die (this has surface rust) , and (2) 9mm C6 dies - I am unsure what these really are - When I bought press used, it came with these and I never used them
Original Instruction manual (November 2015)
Pickup tube end ups (no tubes themselves)
Press is used and shows some signs of wear but otherwise is in great working condition. I bought this press used from someone who said they did not use much and had it in his basement for a couple years without any use. Because of that, on the powder funnel/expansion die there is some surface rust. Like I said, this press is in good working condition and I am unsure if I even want to sell. I am putting this out more as a feeler than anything - Will provide pictures upon request.
Asking $1100 $999
Thanks!
Dillon Electric Case feeder with 9mm feeder plate
Inline Fabrication Raised Mount
Dillon OEM toolhead
Dillon Carbide 9mm dies
Dillon 9mm conversion kit
Lee Factory Crimp Die
Powder measure assembly
Powder Measure Sensor check alarm
Roller handle
Original ball handle
All new springs (all springs for whole press)
Extra 9mm Dies: Lee 9mm B6 Die (this has surface rust) , and (2) 9mm C6 dies - I am unsure what these really are - When I bought press used, it came with these and I never used them
Original Instruction manual (November 2015)
Pickup tube end ups (no tubes themselves)
Press is used and shows some signs of wear but otherwise is in great working condition. I bought this press used from someone who said they did not use much and had it in his basement for a couple years without any use. Because of that, on the powder funnel/expansion die there is some surface rust. Like I said, this press is in good working condition and I am unsure if I even want to sell. I am putting this out more as a feeler than anything - Will provide pictures upon request.
Asking $
Thanks!
Attachments
Last edited: