- Joined
- Aug 12, 2014
- Messages
- 9,613
- Likes
- 9,222
I posted this kind of topic in the equipment forum. It seems to work, have to test iit more when i have a second person. Basically this is how you make a low impedance microphone work with a high impedance consumer radio. These are peltor comtac 3s being used on a kenwood 2 pin style radio adapted from 6 pin. Its not make specific should work with any setup with a similar compatability issue
I hope this is helpful to someone, its alot cheaper than buying airsoft crap or paying for someone to do the same thing.im waiting for some curcuit board to arrive so i can do proper install on 4 PTTs. Ill be back to post final photos before i seal them back up.
Pm me if you want component have enough to make about 60 of them and can probably throw everthing in a regular onvolope with 1 stamp.
I hope this is helpful to someone, its alot cheaper than buying airsoft crap or paying for someone to do the same thing.im waiting for some curcuit board to arrive so i can do proper install on 4 PTTs. Ill be back to post final photos before i seal them back up.
Pm me if you want component have enough to make about 60 of them and can probably throw everthing in a regular onvolope with 1 stamp.
Last edited: