snax
NES Member
just an observation for those looking at different barrel finishes.
had to dimple 2 barrels.
parkerized and nitrided.
that nitride finish is tough, bit had a hard time. cobalt bit. and I dimpled that one first. parkerized cut right into no problem.
both barrels same manufacturer, same steel, only finish was different.
also, sliding the jig on and around the block area to line up the gas port leaves some marks on the parkerized. couldnt see any on the nitride.
had to dimple 2 barrels.
parkerized and nitrided.
that nitride finish is tough, bit had a hard time. cobalt bit. and I dimpled that one first. parkerized cut right into no problem.
both barrels same manufacturer, same steel, only finish was different.
also, sliding the jig on and around the block area to line up the gas port leaves some marks on the parkerized. couldnt see any on the nitride.