GM-GUY
NES Member
So it occurs to me there are many steps to make an AR-15 into an M-16.
M-16 Trigger, disconnector, hammer, selector, auto-sear and BCG
Plus milling the lower additionally and drilling the .125 pin hole
What is the line? it seems that BCGs are fine how many other pieces? Is just possesion of the pieces a bad thing (I made a plexiglass box with the parts inside with a logo that says 'Break Glass in Case of SHTF'
I know that drilling the .125 pin alone, without even milling it will get you locked up.
Since Maura 'interpreted' can the BATFE do this as well or is it set in stone somewhere?
I also know that since the 1986 FOPA - no new Machine Guns are allowed - so I'm not going there. But with the parts problems and shipping issues - if you can get an M-16 Hammer and not an AR-15 hammer.......................
M-16 Trigger, disconnector, hammer, selector, auto-sear and BCG
Plus milling the lower additionally and drilling the .125 pin hole
What is the line? it seems that BCGs are fine how many other pieces? Is just possesion of the pieces a bad thing (I made a plexiglass box with the parts inside with a logo that says 'Break Glass in Case of SHTF'
I know that drilling the .125 pin alone, without even milling it will get you locked up.
Since Maura 'interpreted' can the BATFE do this as well or is it set in stone somewhere?
I also know that since the 1986 FOPA - no new Machine Guns are allowed - so I'm not going there. But with the parts problems and shipping issues - if you can get an M-16 Hammer and not an AR-15 hammer.......................
Last edited: