Need to have brake pinned on

[Fooped]

Hey folks,

I'm looking for someone to pin a Tromix Shark brake on my Tromix Sledgehammer AR barrel. The threads on the brake are not the same as the barrel, as the brake I have is made for a Saiga-12 shotgun. Tony Rumore (Owner of Tromix) said that the threads would need to be hogged out and then the brake pressure-fit onto the barrel and then blind pinned in place. I have all parts in hand, and would like to get this done sooner rather than later. I'm in the Metrowest area, but I'm willing to travel.

Mods, I wasn't sure where to place this thread so move it as you see fit. I figured it would get the best exposure here though.

Thanks in advance!

Baron Gustav Von Foopenheimer III

 

[Squished]

Foops,

I'm willing to bet adco would do it if you shipped to them.

http://www.adcofirearms.com/shopservices/shop_.cfm?code=25

Other the other hand, I'm sure JDL would probably do it as well.

 

[Fooped]

Foops,

I'm willing to bet adco would do it if you shipped to them.

http://www.adcofirearms.com/shopservices/shop_.cfm?code=25

Other the other hand, I'm sure JDL would probably do it as well.

JDL is gone, I believe.

Thanks for the suggestion, but I'm looking for somewhere local if possible.

 

[Len-2A Training]

Why not contact Zero Hour Arms?

They can do that and lighten your wallet with a new purchase at the same time!

 

[JackO]

David Santurri will easily do it for you:
http://santurriltd.com/

 

[icyclefar]

PM sent