Hi,
When I got my SW 686+ new, I experienced light primer issues a lot. So I sent it back to SW and it got better. However I still get light primer quite often (I only shoot double action). Later I learned that you can tighten the strain screw in the font of the bottom of the grip. So I checked it, it is dead tight already.
I can send it back to SW again but I am curious what is the actual problem in terms of the hardware? When I peek into the cylinder sideway to see the firing pin, I see it only protrude a little bit (like 1 mm or less). Is that the problem?
Thank you for any comments.
When I got my SW 686+ new, I experienced light primer issues a lot. So I sent it back to SW and it got better. However I still get light primer quite often (I only shoot double action). Later I learned that you can tighten the strain screw in the font of the bottom of the grip. So I checked it, it is dead tight already.
I can send it back to SW again but I am curious what is the actual problem in terms of the hardware? When I peek into the cylinder sideway to see the firing pin, I see it only protrude a little bit (like 1 mm or less). Is that the problem?
Thank you for any comments.