- Joined
- Jun 21, 2010
- Messages
- 889
- Likes
- 796
This isn't something I usually work on but I will take a special request / challenge occasionally
Rob Pincus didn't like the square trigger guard on his XD. He went to his favorite tool "the Dremel" ........and them he sent it to me...This is not his first time doing this to me!
The trigger guard was fixed and I added an undercut. The beavertail had material removed so you can get a higher grip. The grip safety had material and textured for added insurance for a positive engagement especially with the higher grip. The frame work was finished off with relief cut on both sides of the mag release to assist in manipulating it.
The slide was radius at the front, rear and election port to aid in drawing & holstering. Rob sent me one of his EMS Claw rear sights to be installed. The build was topped off with my Logo and coated with OD Cerakote.
Rob Pincus didn't like the square trigger guard on his XD. He went to his favorite tool "the Dremel" ........and them he sent it to me...This is not his first time doing this to me!
The trigger guard was fixed and I added an undercut. The beavertail had material removed so you can get a higher grip. The grip safety had material and textured for added insurance for a positive engagement especially with the higher grip. The frame work was finished off with relief cut on both sides of the mag release to assist in manipulating it.
The slide was radius at the front, rear and election port to aid in drawing & holstering. Rob sent me one of his EMS Claw rear sights to be installed. The build was topped off with my Logo and coated with OD Cerakote.
![[rofl]](/xen/styles/default/xenforo/smilies.vb/013.gif "ROFL [rofl]")
